Free Siding Contractor Matching Vinyl, Fibre Cement, Wood & Metal Siding Across Ottawa
Find a Siding Contractor

Part of the Ottawa Construction Network

Siding Help for Ottawa Homes

Get matched with local siding contractors for a full re-side, a repair, or a change of material: vinyl, fibre cement, engineered wood, cedar, aluminum or steel. See what the 2024 Ontario Building Code puts behind your siding, when to ask the City first, and what published prices look like before you sign.

Free matching. No phone number needed; contractors reply by email. We do not inspect, license or screen the contractors we forward requests to.

Installer fastening grey lap siding on a gabled house with white trim, with Parliament Hill and the Ottawa River in the background

Half of a Siding Job Is Behind the Siding

Ontario's Building Code treats a house wall as two layers of protection. Here is what that means for a re-side, layer by layer.

What the Building Code puts behind your siding
What the Building Code puts behind your siding Cross-section of a house wall from the inside to the outside: a wood stud, the sheathing, the sheathing membrane with an upper sheet lapped over a lower one, and lap siding boards. A flashing sits at a horizontal joint in the siding. At the bottom, the siding stops above the finished ground. Numbered markers 1 to 6 point to the siding, the membrane, the sheathing, the framing, the flashing and the ground clearance; the numbered list below the drawing gives each requirement. inside outside 1 3 5 2 4 6
  1. Siding: the first plane. Walls around living space need two planes of protection against rain and snow. The siding, with its trim and fasteners, is the first. (9.27.2.2.(4), 9.27.2.3.(1))
  2. Sheathing membrane: the second plane. At least one layer goes beneath siding, joints lapped not less than 100 mm, upper sheets over lower. With flashing, it is the drainage plane that sends water that gets past the siding back outside. (9.27.3.1., 9.27.3.3.)
  3. Sheathing. Vertical vinyl and vertical lumber siding may be nailed to sheathing alone only if it is at least 12.5 mm plywood or OSB, or 14.3 mm lumber. Otherwise siding is fastened to framing, furring or blocking. (9.27.5.1.(1) and (2))
  4. Framing. Nails for vinyl siding reach through the nail-holding base or at least 32 mm into the framing, centred in the slots of the nail hem. (9.27.5.6.(2), 9.27.5.7.)
  5. Flashing. Required at every horizontal junction and offset in the cladding, unless the upper cladding overlaps the lower by at least 25 mm. It runs at least 50 mm up behind the membrane and slopes at least 6% to the outside. (9.27.3.8.(1), (2) and (4))
  6. Ground clearance, moisture-sensitive cladding only. At least 200 mm between finished ground and cladding adversely affected by moisture, such as untreated wood, plywood, OSB, waferboard and hardboard. We found no Code ground clearance for vinyl, metal or fibre cement. (9.27.2.4.(1))

Schematic, not to scale. Ontario Building Code 2024 (O. Reg. 163/24), Division B. No drained-gap dimension is drawn: Ontario's rainscreen sentences in 9.27.2.2. read "Reserved", and the Code's explanatory notes recommend a drained space as best practice rather than require it.

Which siding fits your house?

Three taps. The suggestions come from the Building Code's cladding rules and published Ontario contractor price pages (2025 to 2026), not from a ranking: we found no neutral source that ranks siding materials or publishes their lifespans.

1 The look you want
2 Anything special about the wall?
3 Budget
  • Vinyl or insulated vinyl

    About $5 to $14 per sq ft of wall, installed

    ASTM D3679 (insulated vinyl ASTM D7793); nails centred in the slots, at least 32 mm into framing. (9.27.12.1., 9.27.5.6., 9.27.5.7.)

    Get quotes for this
  • Fibre cement

    About $10 to $25 per sq ft of wall, installed

    No fibre cement subsection in the Code: installed to the general cladding rules and the manufacturer's written instructions. (9.27.1.1.)

    Get quotes for this
  • Engineered wood

    About $9 to $23 per sq ft of wall, installed

    Hardboard to ANSI A135.6, OSB to CSA O437.0; 5 mm gaps at butted ends. (9.27.9., 9.27.10.)

    Get quotes for this
  • Cedar and other wood

    About $10 to $28 per sq ft of wall, installed

    Lumber siding at least 14.3 mm thick; battens overlap boards by at least 12 mm; shingles to CSA O118.1 or O118.2. (9.27.6., 9.27.7.)

    Get quotes for this
  • Aluminum

    About $7 to $18 per sq ft of wall, installed

    Aluminum strip siding to CAN/CGSB-93.2-M; fasteners placed for expansion and contraction. (9.27.11.1., 9.27.5.6.(1))

    Get quotes for this
  • Steel

    Too few published Ontario prices for a range

    At least 0.33 mm thick, CSSBI 23M; too few published Ontario prices for a range. (9.27.11.1.)

    Get quotes for this

Prices: published Ontario contractor price pages, 2025 to 2026, labelled as published quotes, not quotes for your house. We do not rank materials and found no neutral source for siding lifespans; ask for the manufacturer's written warranty, and remember a warranty is not a lifespan.

Is your wall close to the lot line?

On infill lots and semis, the distance from a wall to the lot line (the limiting distance) changes what the Building Code asks of that wall. Ask the City's building official before you choose a material for a wall this close.

  1. 1.2 m or more from the lot line

    The cladding and fire-rating rule for close walls does not apply. (9.10.15.5.(1.1)(a))

  2. 0.6 m to under 1.2 m from the lot line

    The wall needs a fire-resistance rating of not less than 45 minutes. (9.10.15.5.(1.1)(b))

  3. Under 0.6 m from the lot line

    A 45-minute rating, and metal or noncombustible cladding, or vinyl that meets a narrow set of conditions (installed without furring over 12.7 mm gypsum sheathing or masonry, flame-spread rating not more than 25, not more than 2 mm thick). (9.10.15.5.(2))

Ask the City: what is this wall's limiting distance, and which cladding does that allow?

A wall facing a detached garage on the same property is treated differently (9.10.15.5.(4)). Adding exterior insulation thickens the wall toward the lot line. Ontario Building Code 2024 (O. Reg. 163/24), Division B, for houses with no dwelling unit above another.

Frequently Asked Questions

How much does new siding cost in Ottawa?

Published Ontario contractor pages (2025 to 2026) put siding at about $5 to $14 per square foot of wall installed for vinyl, $10 to $25 for fibre cement, $9 to $23 for engineered wood, $7 to $18 for aluminum and $10 to $28 for cedar and natural wood. A full vinyl re-side of a typical house is quoted at roughly $10,000 to $28,000. These are ranges from contractor pages, not quotes; your price depends on the wall area, the trim and what is found behind the old siding.

Do I need a building permit to replace siding in Ottawa?

The City of Ottawa's permit pages do not list siding either way: it is not on the list of exempt projects and not on the list of permit projects. Call the City's Building Code Services before you start, especially if you are adding exterior insulation, replacing structural sheathing, enlarging a window or door opening, or working on a designated heritage property or a house in a Heritage District Overlay.

Do siding contractors need a licence in Ottawa?

We found no City of Ottawa licence and no Ontario licence for siding contractors. The City's only construction-trade licence is for hardscaping (driveways, walkways, patios and similar), and siding is outside it. So ask for other things instead: a written quote, the manufacturer's installation instructions, Working at Heights training for the crew, and WSIB coverage.

Could my old siding contain asbestos?

It could if the house was built before 1990. Health Canada lists exterior siding among the building materials where asbestos was found before 1990, and advises against disturbing asbestos materials yourself. Have it tested before anyone cuts or removes it.

Get Matched Free

Tell us about your siding and we send it to local Ottawa siding contractors

Fields marked are required. No phone number needed — your matches reply by email.

Find a Siding Contractor